Request Product Information
Services
- US, Mexico, Caribbean, and Middle East based operations
- In-field, offshore, and in-facility inspection services
- API, DS-1, and NS-2 Inspection Standards
- Level II and III inspectors are instructed and tested to ASNT SNT-TC-1A standards
Inspection Services
- Electromagnetic Inspection (EMI)
- Special End Area (SEA)
- Magnetic Particle Inspection (MPI)
- Dye Penetrant (PT)
- Multiple Dimensional Measurements
- Thread Gauging
- Marking and Stenciling
- Thread Doping
- Tubular Strapping
- Ultrasonic Inspection (FLUT)
- Wall Data / Wall Mapping / Laser OD Measurement
Hardbanding
- In-Facility and Portable Services
- Capable of hardbanding 2-7/8” to 8-1/2” OD material
- Meets all major hardband wire requirements
- Pendulum method gives a more consistent weld penetration than older models that perform a side-to-side oscillation
Hardband Grinding
- In-Facility & Portable Service
- Grinds hevi-wate center wear pad hardband
- Grinds up to 11” tool joints
- R2 or R3 lengths
- Automated grinding technology
- Removes eccentrically worn hardband on-site with low heat induction to pipe
- Lower heat reduces the chance of heat checking on tool joints, making it easier to apply new hardband
Tubular Management
- Tubular Storage
- Pipe Coating
- Refacing of Drill Pipe and HWDP (Portable)
- Hardbanding of Drill Pipe, HWDP & Drill Collars
- Portable Hardbanding Units
- Hardband Grinding / Removal
- Straightening
RigSafe Rig Mat
Black Diamond’s RigSafe Rig Mat System allows for customized layout and size to fit each specific rig. Fluids easily drain through the mats, into a shallow trough below, allowing for a safe and slip-free work environment.
Composition:
- Synthetic Resin and Reinforced Polypropylene Fiber Matrix
Benefits:
- Fully Recyclable
- Safety
- No Mud Soaked Boards
- Reduced Slips & Falls
- Reduced chemical splash causing hand, eye & skin injuries
- Lower Repair Costs
- Reduced corrosion damages to pin connections
- Reduced tool joint shoulder damage
- Impact & Fatigue Resistant
- Heat & Chemical Resistant
Technical Services & Support
- Deepwater drillstring design / tubular specifications / slip and elevator loading evaluation
- Torque and drag analysis
- Evaluation of bending stresses and buckling loads in directional wells
- Review well diagram (hole sizes, casing depths/sizes, mud weights)
- Review well surveys, DD slide reports, daily reports, mud reports, PASON
- Drill pipe management
- Thread compound selection
- Traceability reporting
- Connection design and performance comparison
- Failure analysis
Straightening Services
- Hydraulic Straightening System for Tubing, Drill Pipe, HWDP, and Drill Collars
- OD Range of 2-3/8” to 6-5/8”
- In-Field (Portable) or In-House Capabilities
